Efergy E2 Spécifications télécharger pdf (Page 5)

INSTALLATION

LINKING TRANSMITTER AND DISPLAY

Feed Wire

1. FIT THE SENSOR

The sensor needs to be fitted to the live feed cable. Sensors are suitable

for cables up to 12mm in diameter. You should not force the cable to fit.

1. Push the release cap

to open the sensor.

3. Close the sensor.

The sensor is secure

when a “click” is heard.

2. Select the correct

feed cable, then place

the feed cable into the

top of the sensor.

2. PLUG THE SENSOR CABLE INTO THE TRANSMITTER

Insert the jack on the end of the white wire into any of the three input sockets on the

transmitter. The clip-on sensor acts as a current sensor and relays the current being

drawn in to the home to the transmitter.

If your cables are too big for the sensor you can order XL-sensors at www.efergy.com

1. Ensure three AA batteries are inserted in the transmitter

and three AAA batteries inserted in the display unit.

2. Push the LINK button on the reverse of the display unit.

The transmission signal symbol will flash for one minute.

3. While the transmission signal in the display flashes push

the learn button in the transmitter and wait until the

transmission signal symbol becomes solid.

NOTE: The default value for the transmission frequency

is six seconds. This means the transmitter is sending

information every six seconds. You can change the

frequency from 6s (red light flashing) to 12s (green light)

and to 18s (orange light) pushing and holding the

transmitter button.

If the LINK is NOT

COMPLETED you will see

dashes on the display

If the LINK is COMPLETED

you will see the transmi-

ssion signal

learn button

link button

transmission signal

1 2 3 4 5 6 7 8 9 10

Pas de commentaire

Efergy E2 Spécifications Page 5