Efergy E2 Spécifications télécharger pdf (Page 6)

SETTING TIME AND DATE

SET-UP INSTRUCTIONS

The efergy monitor needs to know the time and date in order to provide you with the

correct information.

Set the time and date as follows:

STEP 1

On the reverse of the display you will find the TIME button.

Press and hold for two seconds. Time set up will flash in

the display.

STEP 2

Set the hour to the correct time by using UP and DOWN

buttons. Press MODE button once to save the hours. Repeat

for minutes, using the MODE button to confirm.

STEP 3

Set the date by using the UP and DOWN buttons. Press

MODE button

to confirm and move to month set up. Repeat

the process to set the year. Once the correct time and date

have been set, push DATE button to save and exit.

hold for 2 seconds

date button to exit

The efergy monitor needs to know unit cost per kWh charged by your electricity

supplier, along with voltage and alarm settings.The following four steps will move

through each of these settings. If you have dual or multiple tariff rate meter, please

see overleaf.

Press and hold down MODE button for two seconds, this will enable you to enter the

setting mode.

Note: 20 seconds of inactivity in setting mode will

return the unit to normal display mode without saving

changes.

STEP 1. VOLTAGE

Press and hold MODE button for two seconds. Default

voltage is set at 240V. Use UP and DOWN buttons to

change the voltage. Press MODE button to save your

setting and move into currency selection setting.

STEP 2. CURRENCY SELECTION

Select the currency using UP and DOWN buttons. Default

currency will be “£”. Push MODE button to confirm and to

move onto tariff selection set up.

hold for 2 seconds

1 2 3 4 5 6 7 8 9 10

Pas de commentaire

Efergy E2 Spécifications Page 6